Skip to main content

DJI Tinest Drone DJI Spark Disassemble Photos Leaked, With Horizontal Transverse Lens & Obstacle Avoidance Sensor

Recently online news about the new upcoming DJI Drone - DJI Spark is up more gradually. After the real machine appearance spy photos and gimbal running video, and now there are a large number of Spark dismantling photos were exposed, can look at the internal structure of the new machine, it is estimated that there are obstacle sensors.

In addition, DJI Spark's aerial camera seems to be supported by the two-axis gimbal, similar with DJI Inspire 2, it seems only to change the pitch angle up and down. However, because the aerial lens built-in camera, there is a certain virtual position between the camera & body, so there is an analysis that means the lens can be moved horizontally to correct the horizontal amplitude. Does DJI Spark's gimbal system be 2-axis or 3-axis? It is still hard to assert.

Following are DJI Spark Disassemble Photos Leake


↑ ↑ ↑ Spark size is only equivalent to an ordinary iPad mini, previously measured body length of about 14cm.


↑ ↑ ↑ Spark body weight is only 190 grams, it is the lightest DJI Drone till this moment. 


↑↑↑ suspected internal structure of DJI Spark, we can see the machine head installed an obstacle sensor, in order to achieve perceived obstacle avoidance function; The central body is covered with a heat sink, it may be a processor. 


↑ ↑ ↑ After the motherboard is removed, we can see that the back of the motherboard is covered with silver metal.


↑↑↑ Spark circuit layout.


↑ ↑ ↑ Battery compartment design in the Spark fuselage abdomen.


↑ ↑ ↑ Spark tail with microSD card slot and USB interface.


↑ ↑ ↑ Compare with DJI Mavic


↑ ↑ ↑ Compare with DJI Mavic


↑ ↑ ↑ Spark motor also smaller than Mavic's, cause the body is smaller, does not require so much power.


 ↑ ↑ ↑ The lens maybe can be moved horizontally to correct the horizontal amplitude.


↑ ↑ ↑ 2-axis Gimbal seems to be made of plastic material


↑ ↑ ↑ 2-axis gimbal installed six shock-absorbing rubber ball to increase stability.


↑ ↑ ↑ Internal structure of drone head part


↑ ↑ ↑ The module installed in the machine head, mainly composed of a video camera and two LED, which may be monocular vision sensor, in other words, Spark may have visual perception obstacle avoidance function.



↑↑↑ Spark has specialized in aerial APP, can shoot 4K video.

Comments

Popular posts from this blog

How To Extend Hubsan X4 H501S Remote Control Distance?

Hubsan X4 501S is a cost-effective small drone quadcopter, but image transmission distance just about 300 meters, if you want extend the transmission distance, it's easy, even no necessary change the antenna, just follow these 3 steps: 
1. As shown below image, original antenna head is inward direction, put this antenna to get down, let it outward, and as far as possible by remote control edge

2. Like following image, 5.8g receiver original is mounted to the inside, to make it as close to the front, near the remote edges, and pouring sealant.

3. As shown below: separated in the middle with aluminum foil, then gumming, remember higher a little, the back cover just to suppress.

Thus, modification is completed, should be noted that, 2.4G inclined 45 degrees to install, 5.8g flat antenna, please try to tilt outward or parallel with the housing, this can be slightly adjusted by the test. 
Upon completion, re-frequency remote control and aircraft: Press the camera button, open the remo…

Zerotech Hunter Leaked, Looks Like DJI Mavic

Some photos of Zerotech new product, the Hunter, have been leaked, come with folding arm design, very compact size, it is slightly smaller than DJI's first folding drone MAVIC. The battery compartment occupies a large part of the body space, it speculated that duration should be relatively dobby's seven minutes have greatly improved.


With an insider revealed the aircraft life time up to 15 minutes +, and the image transmission distance of up to 1.5KM +


But unfortunately, there is no positive picture of the aircraft, whether equipped with mechanical three-axis gimbal is not known. In order to save costs, still use electronic stability is also possible. This mini folding muotirotor will be a strong competitor to DJI MAVIC,  please stay tuned.

MJX X101 With FPV C4008 Real-Time Image Transmission Camera Review

Although MJX X101 is only a parity exercise drone quadcopter , but built with a gimbal of shock-absorbing function. So, aerial players except the preloaded 720p FPV aerial cameras, also can install GoPro, SJCAM, Xiaomi Xaioyi Action and other sports cameras, to provide a better shooting.
MJX X101 compare with Syma X5SW, the dimension is slightly larger, the dimension is 52.5 x 52.5 x 18.5cm, weight 420 grams, coupled with the use of super magnetic motor, can be said that have reached medium-sized four-axis machine series, the purpose of course is to provide better wind resistance and more stable flight performance. Syma X5SW Explorers 2 FPV RC Quadcopter RTF 360 Degree Eversion Wifi Headless Mode, $74.99, FREE SHIPPING 
X101 installed a shock absorption PTZ, available for load weight of 100 grams, the higher the quality of third-party aerial shoot camera, for example: GoPro, SJCAM, Xiaomi Xaioyi Action and so on. It must be noted that the factory did not come with the relevant camera bu…